Acura 3.5 RL Manual page 1252

Power Windows
Control Unit Input Test (cont'd)
NOTE:
• Before testing, go to the Troubleshooting Guide (see page 23-244). Be sure to go through self-diagnosis function
modes 1 and 2 (see pages
• All connector views are from the wire side of female terminals unless otherwise noted.
Multiplex Control Unit (Passenger's)
1. Remove the right kick panel (see
2. Disconnect the 22P and 26P connectors, then remove the passenger's unit (see page 23-246).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
If a test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the power window master switch (control unit) must be faulty; replace it.
23-248 and 23-252).
section 20).