Power Steering Pump
Reassembly
1.
Install the new pump seal in the pump housing by
hand, then install the pump seal spacer.
NOTE: Insert the pump seal with its grooved side
facing in.
ATTACHMENT, 30 mm
07746-0030300
2.
Position the pump drive shaft in the pump housing,
then drive it in using a special tool as shown.
3.
Install the 40 mm snap ring with its radiused side
facing out.
4.
Coat the pump cover seal and the cover bushing
with the power steering fluid, then install the pump
cover seal into the groove in the pump cover.
5.
Install the outer side plate over the two rollers.
6.
Set the pump cam ring over the two rollers with the
" ° " mark on the cam ring downward.
7.
Assemble pump rotor to the pump cover.
8. Set the 10 vanes in the grooves in the rotor.
NOTE: Be sure that the round ends of the vanes are
in contact with the sliding surface of the cam ring.