Dash Lights Brightness Control Controller Test/Replacement - Acura 3.5 RL Manual

Dash Lights Brightness Control
Controller Test/Replacement
1. Remove the driver's switch panel (see
2. Measure resistance between the No. 3 and No. 4 ter-
minals while rotating the adjusting dial. Resistance
should vary from 0 to 10,000 ohms as the dial is
rotated.
3. Turn the CANCEL switch off by rotating the adjusting
beyond its end position (until if clicks). There should
be no continuity between the No. 2 and No. 6 termi-
nals.
NOTE: The cancel switch is closed with the adjusting
dial between the minimum and maximum positions.
4. If necessary, remove the two screws, and replace the
controller.
section 20).
DRIVER'S SWITCH
PANEL
BULB
(0.84 W)
DASH LIGHTS
BRIGHTNESS
CONTROLLER
SCREWS