Acura 3.5 RL Manual page 928

4. Glue the rubber dam, fasteners, and spacers to the
inside face of the rear window as shown. If neces-
sary, glue the terminal base cover to the rear win-
dow.
NOTE: Be careful not to touch the rear window where
adhesive will be applied.
Spacer, rubber dam, fastener, terminal base cover locations
ALIGNMENT MARK
13 mm
(0.51 in.)
UPPER
SPACER
ALIGNMENT MARKS
13 mm
(0.51 in.)
UPPER
FASTENER
ALIGNMENT MARKS
13 mm
(0.51 in.)
SIDE
SPACER
TERMINAL
BASE COVER
ALIGNMENT
MARKS
ALIGNMENT MARK
13 mm
RUBBER
(0.51 in.)
DAM
ALIGNMENT MARKS
13 mm
(0.51 in.)
SIDE
FASTENER
LOWER SPACER
ALIGNMENT
MARKS
REAR WINDOW
5. Align and glue the molding to the edge of the rear
window.
NOTE: Be careful not to touch the rear window where
adhesive will be applied.
GLASS
MOLDING
50 mm
(2 in.)
Apply primer (3M N-200, or equivalent) to edge
of the windshield.
6. Install the fasteners to the body as shown.
Fastener locations
MOLDING
ADHESIVE
TAPE
REAR WINDOW
50 mm
(2 in.)