5.
Seat the external snap ring into the groove of the
intermediate shaft.
INTERMEDIATE SHAFT
6.
Press the outer seal into the bearing support using
the special tools and a press as shown.
NOTE: Drive in the outer seal until it is 7.0 mm
(0.28 in) from the end of the bearing support.
DRIVER
ATTACHMENT
07MAD-SP00100
±
7.0
0.2 mm
(0.28 ± 0.01 in)
OUTER SEAL
O-RING
7.
Install the new O-ring into the bearing support
groove.
8.
Install the new set ring into the intermediate shaft
groove.
EXTERNAL
SNAP RING
Press
HANDLE DRIVER
07749-0010000