Acura 3.5 RL Manual page 922

Windshield
Installation (cont'd)
5. Glue the molding corner seal to the molding on
each side.
MOLDING
6. Align and glue the molding to the edge of the wind-
shield.
NOTE: Be careful not to touch the windshield
where adhesive will be applied.
Inside
ALIGNMENT
MARK
WINDSHIELD
Alignment mark locations
ALIGNMENT
MARKS
ALIGNMENT
MARK
MOLDING
2.5 mm
CORNER
(0.98 in.)
SEAL
ALIGNMENT
MARK (White)
MOLDING
ADHESIVE
TAPE
MOLDING
WINDSHIELD
Apply primer (3M N-200,
or equivalent) to edge
of the windshield.
7. Install the fasteners to the body as shown.
Fastener locations, 2
8. Set the windshield, then center it in the opening. Make
alignment marks across the windshield and body with
a grease pencil at the four points shown.
NOTE: Be careful not to touch the windshield where
adhesive will be applied.
WINDSHIELD
9. Remove the windshield.
ALIGNMENT MARK