Switch Test/Replacement
1.
Remove the adjustment switch cover, and pull off
the adjustment switch knob (see
2.
Disconnect the 8P connectors from the switch, then
remove the switch from the cover by removing its
two mounting screws.
SEAT ADJUSTMENT SWITCH
Terminal side of male terminals
3.
Check for continuity between the terminals in each
switch position according to the table.
Terminal
Position
FORWARD
SLIDE
SWITCH
BACKWARD
FORWARD
RECLINE
SWITCH
BACKWARD
section
20).
FRONT PASSENGER'S POWER
Motor Test
CAUTION: Be careful not to damage the seat, interior
trim or body.
1. Remove the front passenger's seat (see
2.
Disconnect the 2P connector from each power seat
motor.
SLIDE MOTOR
Terminal side of male terminals
3.
Test the motor according to the table.
Terminal
Position
FOR-
WARD
SLIDE
MOTOR
BACK-
WARD
FOR-
WARD
RECLINE
MOTOR
BACK-
WARD
CAUTION: When a motor stops running, disconnect
battery power immediately.
4.
If the motor does not run or fails to run smoothly,
replace it (see
section
section
RECLINE
MOTOR
20).
20).