Position - Acura 3.5 RL Manual

Switch Plate Adjustment (Fully Closed Position/Auto Stop Position)
1. Remove the headliner (see page 20-45).
2. Using the moonroof wrench, close the glass fully.
NOTE: Check the glass fit to the roof panel.
3. Using an open-end wrench, loosen the switch plate A mounting bolts.
4. Adjust position of switch plate A (switch cam) as shown.
NOTE:
Move switch plate A a little at a time, then secure switch plate A at the position where the switch cam contacts the
closed position switch (a faint click is heard).
Check that switch plate A contacts the cable bracket.
CABLE BRACKET
Forward
SWITCH CAM
CABLE BRACKET
CLOSED

POSITION

SWITCH
SWITCH
PLATE A
INNER CABLE END
SWITCH
PLATE A
GUIDE PLATE
SLIDER
OPEN-END
WRENCH
CABLE
BRACKET
SWITCH PLATE A
BOLTS
GLASS