Acura 3.5 RL Manual page 638

Link Adjustment
• Make sure lifts, jacks and safety stands are placed
properly (see section 1).
• Apply parking brake, and block rear wheels so vehi-
cle will not roll off stands and fall on you while work-
ing under it.
1. Shift the transmission into the
2. Remove the center console (see
3. Remove the lock pin from the link adjuster.
LOCK PIN
LINK ROD
4. Insert a 4.0 mm (0.16 in) pin into the shift lever bracket
through the position cutout of the shift lever.
CAUTION: Be sure to use a 4.0 mm (0.16 in) pin.
SHIFT LEVER
POSITION
position.
section 20).
LINK ADJUSTER
A/T GEAR POSITION
PANEL
4.0 mm PIN
POSITION HOLE
5. Verify that the shift position is in the
the transmission.
A/T GEAR
POSITION SWITCH
6. Turn the ignition switch ON (II), verify that the
indicator light comes on.
CAUTION: Do not start the engine.
GAUGE ASSEMBLY
position on
SHIFT CABLE
CONTROL LEVER
INDICATOR
LIGHT
A/T GEAR POSITION
INDICATOR