Lighting System
Automatic Lighting Control Unit Input Test (USA)
1. Remove the rear seat-back.
2. Disconnect the 14P connector from the control unit.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input test probe OK, the control unit must be faulty; replace it.
BLK/YEL
RED/YEL
Wire side of
female terminals
BRN
BLK
14P CONNECTOR
YEL/GRN
BLU/RED
YEL/BLK
BLK
GRN/BLU
WHT/YEL
GRN/YEL
AUTOMATIC LIGHTING
CONTROL UNIT
RED/GRN