14. Shift to the respective shift lever position, and measure each clutch pressure.
LINE PRESSURE
INSPECTION HOLE
4TH CLUTCH
PRESSURE
INSPECTION HOLE
3RD CLUTCH
PRESSURE
INSPECTION HOLE
THROTTLE B
PRESSURE
INSPECTION HOLE
15. Disconnect the transmission sub-harness connector (14P), then measure throttle B pressure with the throttle fully opened.
16. Connect battery voltage to the A/T clutch pressure control solenoid valve terminals of the transmission sub-harness
connector as shown.
17. Measure throttle B pressure at the fully closed throttle condition.
18. Install the sealing bolts with new sealing washers in the inspection holes, and tighten the bolts to the specified torque.
TORQUE: 18 N-m (1.8 kgf-m, 13 Ibf-ft)
NOTE: Do not reuse old sealing washers.
1ST CLUTCH PRESSURE
INSPECTION HOLE
REVERSE CLUTCH PRESSURE
INSPECTION HOLE
1ST-HOLD CLUTCH PRESSURE
INSPECTION HOLE
2ND CLUTCH PRESSURE
INSPECTION HOLE