Acura 3.5 RL Manual page 633

3. Install the transmission range switch on the control
shaft, then install the bolts loosely.
TRANSMISSION
RANGE SWITCH
6 x 1.0 mm
Tighten loosely.
4. Install a new lock washer on the transmission range
switch by aligning its projected tip with the
tion mark on the transmission range switch as
shown.
POSITION
TRANSMISSION RANGE
MARK
SWITCH
LOCK WASHER
Replace.
LOCKNUT
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
5. Tighten the locknut while holding the detent lever in
the position, then bend the lock tabs against the
locknut.
6. Tighten the 6 mm bolts to the specified torque.
CONTROL
SHAFT
posi-
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
DETENT
LEVER
CONTROL
SHAFT