Rear Suspension; Hub Bearing Unit - Acura 3.5 RL Manual

Rear Suspension

Hub Bearing Unit Replacement
NOTE:
• Use only genuine Honda wheel weights for aluminum wheels. Non-genuine wheels weights may corrode and damage
aluminum wheels.
• Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.
FLANGE NUT
16 x 1.5 mm
140 N-m (14.3 kgf-m, 103 Ibf-ft)
FLANGE NUT 10 x 1.25 mm
38 N-m (3.9 kgf-m, 28 Ibf-ft)
Inspect surface for damage.
PARKING BRAKE ASSEMBLY
Do not disassemble.
O-RING
Replace.
BRAKE DISC
Check for wear and
rust.
Inspection,
Section 19.
FLAT-HEAD SCREW
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)

HUB BEARING UNIT

Inspect for faulty
movement and wear.
SPINDLE WASHER
HUB CAP
Replace.
SPINDLE NUT
24 x 1.5 mm
Replace.
245 N-m (25.0 kgf-m, 181 Ibf-ft)
NOTE: After tightening, use a drift to
stake the spindle nut shoulder against
the spindle.
WHEEL NUT
12 x 1.5 mm
108 N-m (11 kgf-m, 80 Ibf-ft)
WHEEL CENTER CAP