Acura 3.5 RL Manual page 700

Component Locations
Index
NOTE:
• If an intact airbag assembly has been removed from a scrapped vehicle or has been found defective or damaged dur-
ing transit, storage or service, it should be deployed (see
• Before removing the gearbox, remove the driver's airbag assembly and steering wheel.
• After installing the gearbox, check the wheel alignment and adjust it if necessary.
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS
(section 24) before performing repairs or service.
RESERVOIR
Fluid Replacement, page
Fluid Leakage Inspection, page
POWER STEERING SPEED SENSOR
Replacement, page
17-16
17-23
POWER STEERING PUMP
Pump Belt Inspection and
Adjustment, page 17-15
Pump Pressure Check, page
Removal/Installation, page
Disassembly, page 17-25
Inspection, page 17-26
Reassembly, page 17-28
17-13
STEERING GEARBOX
Rack Guide Adjustment, page
Removal, page
Disassembly, page
Reassembly, page
Installation, page
VALVE BODY UNIT
Overhaul, page
section 24).
STEERING WHEEL
Removal and Installation, page
Disassembly/Reassembly, page
DRIVER'S AIRBAG ASSEMBLY
Removal/Installation, see
17-17
17-24
17-16
17-30
17-32
17-40
17-51
17-36
17-18
17-19
section 24
STEERING COLUMN
Removal/Installation, page
Inspection, page 17-21
Steering Lock Replacement, page
Inspection for Driving Position
Memory System (DPMS), see
CABLE REEL
Removal/Installation,
see section 24
IGNITION SWITCH
Inspection and Replacement,
see section 23
TIE-ROD END BALL JOINT
Ball Joint Boot Replacement,
page 17-53
17-20
17-22
section 23