Disassembly - Acura 3.5 RL Manual

Intermediate Shaft

Disassembly

NOTE: The bearing support is made of aluminum. Be
careful not to damage it when servicing.
1. Remove the set ring.
BEARING SUPPORT
2. Remove the intermediate shaft outer seal from the
bearing support.
3. Remove the external snap ring and the internal
snap ring.
SET RING
Replace.
OUTER SEAL
Replace.
EXTERNAL SNAP RING
INTERNAL SNAP RING
4. Press the intermediate shaft out of the shaft bearing
using a press as shown.
INTERMEDIATE SHAFT
Check for damage.
5. Press the intermediate shaft bearing out of the bear-
ing support using the special tools and a press as
shown.
Press
DRIVER
ATTACHMENT,
42 x 47 mm
07746-0010300
Press
HANDLE DRIVER
07749-0010000
INTERMEDIATE
SHAFT
BEARING
Replace.