Solenoid Valve - Acura 3.5 RL Manual

A/T Clutch Pressure Control Solenoid Valve
Test
1. Disconnect the transmission sub-harness connector
(HP).
TRANSMISSION SUB-HARNESS
CONNECTOR (14P)
2. Measure the resistance between the No. 8 and No. 9
terminals of the transmission sub-harness connector.
STANDARD: 4.0 - 6.0
3. If the resistance is out of specification, remove the
shift cable cover, and disconnect the shift solenoid
valve/A/T clutch pressure control solenoid valve
harness connector.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
SHIFT CABLE
COVER
Terminal side of
male terminals
(at 70°F, 20°C)
CLAMP
4. Measure the resistance between the No. 3 and No. 4
terminals of the shift solenoid valve/A/T clutch pres-
sure control solenoid valve harness connector.
STANDARD: 4.0 - 6.0
• If the resistance is within specification, replace
the transmission sub-harness.
• If the resistance is out of specification, replace
the A/T clutch pressure control solenoid valve.
5. If the resistance is within the standard, connect the
No. 4 terminal of the shift solenoid valve/A/T clutch
pressure control solenoid harness connector to the
battery positive terminal, and connect the No. 3 ter-
minal to the battery negative terminal. A clicking
sound should be heard. If no clicking sound is heard,
replace the A/T clutch pressure control solenoid
valve.
NOTE: If A/T clutch pressure control solenoid valve
replacement is required, see these headings:
• Lower Valve Body
Removal/Installation ...................................
Disassembly/Reassembly ..........................
• Throttle Valve Body/A/T Clutch Pressure Control

Solenoid Valve

Replacement ...............................................
(at 70°F, 20°C)
SHIFT SOLENOID VALVE/
A/T CLUTCH PRESSURE
CONTROL SOLENOID VALVE
HARNESS CONNECTOR
Terminals side of
male terminals
14-112
14-113
14-114