Removal/Installation - Acura 3.5 RL Manual

VSA Off Switch
Test
1. Remove the VSA off switch from the switch panel.
2. Check for continuity between terminal No. 1 and
No. 2 (illumination light circuit) and between termi-
nal No. 3 and No. 4 (switch circuit).
There should be continuity when the switch is
pushed, and there should be no continuity when the
switch is released.
VSA OFF SWITCH
6P CONNECTOR
Terminal side of male terminals
VSA OFF SWITCH
VSA Converter Unit

Removal/Installation

1. Remove the glove box.
2. Remove the glove box back cover.
3. Remove the right front door trim.
4. Remove the right kick panel.
5. Lift up the floor mat.
6. Remove the PCM cover.
7. Remove the connectors inside of the right kick
panel.
8. Remove the harness clip A from the VSA converter
unit, then remove the bolt on the lower side of the
VSA converter unit.
9. Remove the multiplex control unit (passenger's).
10. Remove the harness clip B and C.
11. Remove the bolt at the rear of the VSA converter
unit, then pull out the VSA converter unit.
HARNESS CLIP B
VSA CONVERTER UNIT
HARNESS
CLIP A
MULTIPLEX CONTROL
UNIT (PASSENGER'S)
12. Install the VSA converter unit in the reverse order of
removal.
CONNECTORS
(Inside the
right kick panel.)
HARNESS CLIP C