Park Pin Switch Test/Replacement
1. Remove the center console (see
2.
Disconnect the park pin switch 2P connector.
SHIFT LEVER
Push the shift lever to the right
in the direction shown.
Terminal side of
male terminals
3.
Check for continuity between the terminals in each
switch lever position according to the table.
4.
If necessary, replace the park pin switch.
section
20).
PARK PIN
SWITCH
PARK PIN
SWITCH 2P
CONNECTOR
5.
Remove the screw, then remove the park pin switch
from the base bracket.
PARK PIN
SWITCH
SCREW
5 x 0.8 mm
4 N-m (0.4 kgf-m, 3 Ibf-ft)