Acura 3.5 RL Manual page 923

10. With a sponge, apply a light coat of glass primer
around the edge of the windshield as shown, then
lightly wipe it off with gauze or cheesecloth.
NOTE:
Do not apply body primer to the windshield, and
do not get body and glass primer sponges mixed
up.
Never touch the primed surfaces with your hands.
If you do, the adhesive may not bond to the wind-
shield properly, causing a leak after the windshield
is installed.
Keep water, dust, and abrasive materials away
from the primed surface.
Apply glass primer here.
SIDE RUBBER
Apply glass
DAM
primer to the
molding.
Inside
MOLDING
WINDSHIELD
WINDSHIELD
SIDE
RUBBER
DAM
LOWER RUBBER
DAM
WINDSHIELD
*: USA Model • JH4KA9651TC011166-
Canada Model • JH4KA9656TC800364-
MOLDING
Apply glass primer
to the molding.
9 mm
(0.35 in.)
Inside
MOLDING
FASTENERS
SIDE
RUBBER
DAM
WINDSHIELD
LOWER RUBBER
DAM
Inside
11. With a sponge, apply a light coat of body primer to
the original adhesive remaining around the wind-
shield opening flange. Let the body primer dry for
at least 10 minutes.
NOTE:
Do not apply glass primer to the body, and be care-
ful not to mix up glass and body primer sponges.
Never touch the primed surfaces with your hands.
Mask off the dashboard before painting the flange.
: Apply body primer here.
20 mm (0.79 in.)
20 mm
(0.79 in.)
12. Before filling a cartridge, cut the end of the nozzle
as shown.
Cut nozzle end
as shown.
20 mm
(0.79 in.)
10 mm (0.39 in.)
7 mm (0.27 in.)