Trunk Light Test
1.
Pry the trunk light lens off from the housing.
2P CONNECTOR
LENS
2.
Pry out the light assembly.
3.
Disconnect the 2P connector from the housing.
4.
Make sure the bulb, and check for continuity
between the No. 1 and No. 2 terminals.
HOUSING
BULB
(5 W)
Glove Box Light Test
1.
Open the glove box, and disconnect the 2P
connector.
NOTE: If necessary, remove the glove box.
2.
Check for continuity between the terminals in each
switch position according to the table.
BULB (3.4 W)