Ignition Switch; Test - Acura 3.5 RL Manual

Ignition Switch

Test

SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS (section 24) before performing repairs or
service.
NOTE: The PCM memory must be reset after reconnecting
the battery (see section 11).
1. Make sure you have the anti-theft code for the radio
and the navigation system, then write down the fre-
quencies for the radio's preset buttons.
2. Disconnect the battery negative cable.
3. Remove the dashboard lower cover (see
4. Disconnect the 7P connector from the under-dash
fuse/relay box.
7P CONNECTOR
WHT
BLK/WHT
Wire side of
female terminals
section
BLK/YEL
YEL
WHT/RED
5. Check for continuity between the terminals in each
switch position according to the table.
6. If the continuity checks do not agree with the table,
replace the electrical switch.
20).
7. After reconnecting the battery, enter the anti-theft
code for the radio and the navigation system, then
enter the customer's radio station presets.