Front Seat Lumber Support Replacement - Acura 2002 RSX Service Manual

Seats
Front Seat Gover Replacement
(cont'dl
9. Installthe cover in the reverse order of removal.
and note these items:
. To prevent wrinkles when installing a seat
cushion cover, make sure the material is
stretched evenly over the pad before securing
the clips and hooks.
. Make sure the side airbag harness and OPDS
harness (passenger's seat) are routed properly.
. Replace any clips you removed with new ones
(A). Install them with commerciallv available
upholstery ring pliers (B).
20-80
Front Seat Lumbar Support
Replacement
For Some Models {Driver's seat}
SRS components are located in this area. Review the
SRS component locations (see page 23-10) and the
precautions and procedures (see page 23-1 1) in the SRS
section before performing repairs or service.
NOTE;
. Take care not to tear the seams or damaqe the seat
covers.
. Put on gloves to protect your hands.
1. Remove the front seat (see page 20-72).
2. From under the seat cushion, detach the side
airbag connector clip. Release the seat cushion
cover from the seat cushion frame spring, then pull
the cover back, and remove the harness bands (see
page 20-76).
3. Release the hook, and unzip the seat-back cover.
Pull the side airbag harness outthrough the hole in
the seat cushion cover (see page 20-76).
4. Remove the side airbag (see page 23-131).
5. Detach the clips (A) ofthe alrbag module holder (B)
from the seat-back frame.