Replacement - Acura 3.5 RL Manual

Replacement

NOTE: Torque converter clutch (lock-up control)
solenoid valves A and B must be replaced as an assem-
bly.
1. Remove the mounting bolts and torque converter
clutch solenoid valves A and B.
6 x 1.0 mm
12 N-m
(1.2 kgf-m, 8.7 Ibf-ft)
FILTER/GASKET
Replace.
Install in this
direction.
2. Clean the mounting surface and fluid passages of
the torque converter clutch solenoid valves A and B,
and install a new torque converter clutch solenoid
valves A and B with a new filter/gasket.
NOTE: Install the filter/gasket in the direction shown.
3. Check connector for rust, dirt or oil, then reconnect
the connector securely.
TORQUE CONVERTER CLUTCH
SOLENOID VALVES
A AND B
Clean mounting surface
and fluid passages