Acura 3.5 RL Manual page 592

Regulator Valve Body
Disassembly/Inspection/Reassembly
NOTE:
• Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air.
• Blow out all passages.
• Replace the valve body as an assembly if any parts are worn or damaged.
• Check all valves for free movement. If any fall to slide freely, see Valve Body Repair on page 14-136.
1. Hold the regulator spring cap in place while removing the stop bolt. The regulator spring cap is spring loaded. Once the
stop bolt is removed, release the spring cap slowly so it does not pop out.
2. Reassembly is the reverse of disassembly.
NOTE:
• Coat all parts with ATP during assembly.
• Align the hole in the regulator spring cap with the hole in the valve body, then press the spring cap into the body
and tighten the stop bolt.
COOLER RELIEF
VALVE
SPRING
SEAT
VALVE CAP
ROLLER
SPRING SPECIFICATIONS
REGULATOR
VALVE BODY
Inspect for wear, scratches,
and scoring.
REGULATOR
VALV E
LOCK-UP SHIFT VALVE
STOP BOLT
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
REGULATO R
SPRING SEAT
*: Inside Diameter
REGULATOR
SPRING CAP
Unit: mm (in)