Driver's Power Seat Position Sensor Test - Acura 3.5 RL Manual

Driver's Power Seat Position Sensor Test

CAUTION: Be careful not to damage the seat, interior
trim or body.
1. Remove the driver's seat (see
2. Disconnect the connector from each power seat
memory sensor and motor.
REAR
UP-DOWN
POSITION
SENSOR
SLIDE
POSITION
SENSOR
section 20).
RECLINE
POSITION
SENSOR
FRONT
UP-DOWN
POSITION
SENSOR
3. Test the sensor by connecting power and ground to
the motor, and connect an analog ohmmeter test
leads to the sensor connector.
The needle in the ohmmeter should move from left
to right.
CAUTION: When a motor stops running, discon-
nect power immediately.
NOTE: If a motor does not run, reverse power and
ground. If the motor still does not run, replace the
motor.