Acura 3.5 RL Manual page 909

Doors
Glass/Quarter Glass/Regulator Removal (cont'd)
3. Remove the glass run channel as needed, remove
the bolts and screw, then move the rear channel
forward.
Bolt, screw locations
6 x 1.0 mm
9 N-m (0.9 kgf-m,
7 Ibf-ft)
GLASS RUN
CHANNEL
4. Remove the quarter glass.
NOTE: When installing the quarter glass, make sure
the outer molding lip is not pinched.
4 x 0.8 mm
4 N-m (0.4 kgf-m,
3 Ibf-ft)
REAR
CHANNEL
Screw locations
QUARTER
GLASS
OUTER
MOLDING
5. Disconnect the connector, then remove the regula-
tor through the hole in the door.
Bolt locations, 7
6 x 1.0 mm
8 N-m (0.8 kgf-m,
6 Ibf-ft)
REGULATOR
Loosen.
6. Grease all the sliding surfaces of the regulator where
shown.
REGULATOR
7. Installation is the reverse of the removal procedure.
NOTE: Roll the glass up and down to see if it moves
freely without binding. Also make sure that there is
no clearance between the glass and glass run channel
when the glass is closed. Adjust the position of the
glass as necessary (see page 20-16).
CONNECTOR
Loosen.
POWER
WINDOW
MOTOR
Loosen.
POWER WINDOW
MOTOR