Mirror Holder Removal
NOTE: Take care not to scratch the mirror housing.
1.
Pry the mirror holder out from the bottom until you
can see the actuator, then detach the hooks using a
flat tip screwdriver.
CAUTION: When prying with a flat-tip screwdriver,
wrap it with a shop towel to prevent damage.
MIRROR
HOUSING
SHOP
TOWEL
2.
Detach the hooks, disconnect the defogger connec-
tor (if so equipped), then remove the mirror holder
from the actuator.
ACTUATOR
HOOK
3.
Installation is the reverse of the removal procedure.
ADHESIVE TAPE
HOOKS
MIRROR
HOLDER
DEFOGGER
CONNECTOR
MIRROR HOLDER