Indicator Input Test - Acura 3.5 RL Manual

Safety Indicator

Indicator Input Test

1. Remove the gauge assembly (see page 23-85).
2. Disconnect the connectors from the gauge assembly.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input test prove OK, the gauge printed circuit panel must be faulty; replace it.
22P CONNECTOR "A" (C508)
30P CONNECTOR "B" (C509)
WHT/GRN
WHT/YEL BLK
GRN/ORN GRN/RED
GRN/YEL
GRN/BLK
BLK
Wire side of
female terminals
GRN/BLU
Wire side of
female terminals