Backprobing Spring-Loaded Lock Connectors; Disconnecting The Airbag Connectors And Seat Belt Tensioner Connectors ('96-98 Models); Disconnecting The Airbag; Connectors And Seat Belt - Acura 3.5 RL Manual

Backprobing Spring-loaded Lock
Connectors
• When checking voltage or resistance on this type of
connector the first time, it is necessary to remove the
retainer to insert tester probes from the wire side.
NOTE: It is not necessary to reinstall the removed
retainer; the terminals will stay locked in the connec-
tor housing.
• To remove the retainer, insert a flat tip screwdriver
between connector body and retainer, and carefully
pry out the retainer.
NOTE: Take care not to break the connector.

Disconnecting the Airbag

Connectors and Seat Belt

Tensioner Connectors

'96 - 98 Models
Before removing an airbag or other SRS related devices
(the SRS unit and the cable reel), disconnecting connec-
tors from SRS related devices, or removing the dash-
board or the steering column, disconnect the airbag
connectors to prevent accidental deployment.
Turn the ignition switch OFF and disconnect the nega-
tive cable from the battery, and wait at least 3 minutes
before beginning the following procedures.
• Before disconnecting the SRS main harness 18P con-
nector (A) from the SRS unit, disconnect both airbag
2P connectors (C, D) and both seat belt tensioner 2P
connectors (F, H).
• Before disconnecting the cable reel 2P connector (B),
disconnect the driver's airbag 2P connector (C).
• Before disconnecting the left side wire harness 2P
connector (E), disconnect the driver's seat belt ten-
sioner 2P connector. (F).
• Before disconnecting the right side wire harness 2P
connector (G), disconnect the front passenger seat
belt tensioner 2P connector (H).
Refer to page 24-33 for the disconnect the connector(s).