Power Mirror Control Unit Input Test - Acura 3.5 RL Manual

Driving Position Memory System (DPMS)

Power Mirror Control Unit Input Test

1. Remove the driver's door panel (see
2. Disconnect the power mirror control unit connectors.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
If a test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, substitute a known-good control unit, and recheck the system.
NOTE:
• If all the control unit (steering column, power seat, power mirror) input tests prove OK, disconnect all three
control units, and check for opens or shorts in the communication lines.
• All connector views are from wire side of female terminals.
section 20).
POWER MIRROR CONTROL UNIT
12P CONNECTOR "A"
BLU/GRN
LT GRN/RED
BLK/WHT
16P CONNECTOR "B"
WHT/YEL ('99 - 01 models)
RED/YEL ('96 - 98 models)
YEL
BLK
BLU
BLU/ORN
RED/WHT
WHT/YEL
BLK
BLU
YEL/BLK
YEL
GRN/WHT
GRN
BRN
RED/BLK
YEL
GRY
BLU
BRN/WHT
GRY
BRN