Hazard Warning Switch Test
With Navigation System
1.
Remove the navigation display unit (see page
23-415).
2.
Disconnect the 6P connector from the switch.
HAZARD WARNING
SWITCH
BULB (0.84 W)
6P CONNECTOR
3.
Remove the switch from the navigation display unit.
4.
Check for continuity between the terminals in each
switch position according to the table.
Without Navigation System
1. Remove the hazard warning switch.
2. Disconnect the 5P connector from the switch.
HAZARD
WARNING
SWITCH
BULB (0.84 W)
3.
Check for continuity between the terminals in each
switch position according to the table.
5P CONNECTOR