Under-Dash Fuse/Relay Box; Removal/Installation - Acura 3.5 RL Manual

Under-dash Fuse/Relay Box

Removal/Installation

SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS (section 24) before performing repairs or service.
NOTE: The PCM memory must be reset after reconnecting
the battery (see section
Removal:
1. Make sure you have the anti-theft code for the radio
and the navigation system, then write down the fre-
quencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then
disconnect the positive cable, and wait at least
3 minutes.
3. Disconnect the airbag connectors (see
4. Disconnect the connectors from the under-dash fuse/
relay box, including the SRS main harness (see
section 24).
UNDER-DASH FUSE/RELAY BOX
BOLT
5. Remove the dashboard lower cover (see
6. Remove the mounting nut and bolt, and pull the
under-dash fuse/relay box out from under the dash.
11).
section
SRS MAIN HARNESS
NUT
section
Installation:
1. Connect the connectors to the under-dash fuse/relay
box, then install the under-dash fuse/relay box in the
reverse order of removal (see
2. Install the dashboard lower cover (see
3. Connect the airbag connectors (see
4. Connect the battery positive cable, then connect the
negative cable.
5. Confirm that all systems work properly.
6. Enter the anti-theft code for the radio and the navi-
gation system, then enter the customer's radio sta-
24). tion presets.
20).
section 24).
section 20).
section 24).