Acura 3.5 RL Manual page 1042

Temperature Control
Adjustment
Heater valve side:
1. Open the cable clamp, then disconnect the heater
valve cable from the heater valve arm.
CABLE CLAMP
Turn the ignition switch ON (II). Set the temperature
2.
control dial on MAX COOL with the A/C on.
NOTE: Do not start the engine.
Turn the heater valve arm to the fully closed posi-
3.
tion as shown above, then attach the heater valve
cable to the heater valve arm. Hold the heater valve
arm in the closed position, and gently pull on the
heater valve cable housing to take up any slack,
then install the heater valve cable housing into the
cable clamp.
HEATER VALVE ARM
HEATER VALVE CABLE
Table of Contents
Heater unit side:
1. At the heater unit, disconnect the heater valve cable
housing from the cable clamp, then disconnect the
heater valve cable from the temperature control
arm.
TEMPERATURE
CONTROL ARM
STOP
2. Set the air mix control motor on MAX COOL (see
page 22-57).
3. Attach the heater valve cable to the temperature con-
trol arm as shown above. Hold the end of the heater
valve cable housing against the stop, then snap the
heater valve cable housing into the cable clamp.
HEATER VALVE CABLE
CABLE CLAMP