Power Steering Gearbox
Disassembly (cont'd)
11. Remove the two flange bolts, then remove the valve
body unit from the gearbox (see page
body unit disassembly).
12. Drill a 3 mm (0.12 in) diameter hole approximately
2.5 - 3.0 mm (0.10 - 0.12 in) in depth in the staked-
point on the cylinder.
NOTE:
• Do not allow metal shavings to enter the cylinder.
• After removing the cylinder end, remove any
burrs at the stake point.
13. Install the special tool on the gearbox housing.
17-36
for valve
14. Clamp the tool in a vise with soft jaws as shown,
15. Remove the gearbox housing from the vise, and set
16. Insert a 6" long, 3/8" drive extension into the spe-
CYLINDER END SEAL
REMOVER ATTACHMENT
07NAD-SR3020A
17. Press the cylinder end seal and steering rack out of
CAUTION: Do not clamp the cylinder housing.
then loosen and remove the cylinder end.
it in a press so the gearbox points upward.
cial tool.
the gearbox housing.
NOTE: Hold the steering rack to keep it from falling
when pressed clear.
CAUTION: Be careful not to damage to inner sur-
face of the cylinder wall with the tool.