Moonroof
Motor Test
1. Remove the right rear pillar trim (see
2.
Disconnect the moonroof harness 2P connector
from the right side wire harness.
2P CONNECTOR
RIGHT SIDE
WIRE HARNESS
3.
Test the motor by connecting power and ground
according to the table.
If the motor fails to run or does not run smoothly,
go to step 4.
section
20).
Terminal side of
male terminals
4.
Carefully remove the headliner (see
5.
Disconnect the 2P connector from the moonroof
motor.
MOONROOF MOTOR
Terminal side of
male terminals
6.
Test the motor by connecting power and ground
according to the table.
• If the motor runs smoothly, repair the moonroof
wire harness.
• If the motor fails to run or does not run smoothly,
replace the motor (see
NOTE: See closing force check in
motor clutch test.
section
20).
2P CONNECTOR
section
20).
section 20
for