Pump Belt - Acura 3.5 RL Manual

Pump Belt

NOTE: When using a new belt, first adjust the deflection
or tension to the values for the new belt, then readjust
the deflection or tension to the values for the used belt
after running engine for 5 minutes.
Inspection
Attach the special tool to the belt, and measure the ten-
sion of the belt.
Tension:
Used Belt: 340 - 540 N (35 - 55 kgf, 77 - 120 Ibf)
New Belt: 690 - 880 N (70 - 90 kgf, 154 - 200 Ibf)
NOTE:
• If there are cracks or any damage evident on the belt,
replace it with a new one.
• Follow the manufacturer's instructions for the tension
gauge.
BELT TENSION GAUGE
07JGG - 001010A
Inspect the pump belt for cracks or any damage.
Replace the belt with a new one if necessary.
Measurement without Belt Tension Gauge:
Apply a force of 98 N (10 kgf, 22 Ibf), and measure the
deflection between the power steering pump and the
crankshaft pulleys.
Deflection:
Used Belt: 10.5 - 12.5 mm (0.41 - 0.49 in)
New Belt: 7.5 - 9.0 mm (0.30 - 0.35 in)
Adjustment
1. Remove the air cleaner (ACL).
2. Loosen the power steering pump mounting nut and
bolt.
3. Turn the adjusting bolt to get the proper belt ten-
sion, then retighten the nut and bolt.
4. Start the engine and turn the steering wheel from
lock-to-lock several times, then stop the engine and
recheck the deflection of the belt.
5. Install the air cleaner (ACL).