Electrical Switch Replacement
SRS components are located in this area. Review the
SRS component locations, precautions,and procedures
in the SRS
(section
24) before performing repairs or
service.
NOTE: The PCM memory must be reset after reconnecting
the battery (see
section
11).
1.
Make sure you have the anti-theft code for the radio
and the navigation system, then write down the fre-
quencies for the radio's preset buttons.
2.
Disconnect the battery negative cable.
3. Remove the dashboard lower cover (see
4.
Disconnect the 7P connector from the under-dash
fuse/relay box.
5. Remove the steering column covers (see
6.
Insert the ignition key, and turn it to "0".
7.
Remove the two screws and the electrical switch
from the steering lock.
SWITCH
8.
After reconnecting the battery, enter the anti-theft
code for the radio and the navigation system, then
enter the customer's radio station presets.
section
20).
section
17).
LOCK CYLINDER