Acura 3.5 RL Manual page 768

NOTE: Wash the knuckle and hub thoroughly in
high flash point solvent before reassembly.
31. Press a new wheel bearing into the knuckle using
the old bearing, plate and a press.
KNUCKLE
SUPPORT
BASE
07965-6920201
32. Install the snap ring securely in the knuckle groove.
SNAP RING
Press
PLATE
OLD BEARING
WHEEL BEARING
DRIVER ATTACHMENT
78 x 90 mm
07GAD-SD40101
KNUCKLE
33. Install the splash guard, and tighten the screws.
6 mm SCREW
4.9 N-m (0.5 kgf-m, 4 Ibf-ft)
34. Place the front hub in the special tool fixture, then
set the knuckle in position, and apply downward
pressure using the special tools and a press.
FRONT
HUB
ATTACHMENT,
72 x 75 mm
07746-0010600
SUPPORT
BASE
07965-SD90100
35. Install in reverse order of removal.
SPLASH
GUARD
ATTACHMENT,
42 x 47 mm
07746-0010300
Press
WHEEL BEARING