Acura 3.5 RL Manual page 1451

SRS Unit
Replacement (cont'd)
CAUTION:
• Be sure to install the SRS wiring so that it is not
pinched or interfering with other vehicle parts.
• When tightening the Torx bolts to the specified
torque after replacement, be careful to turn them in
so that their heads rest squarely on the brackets.
7. Install the new SRS unit.
'96 - 98 Models
'99 - 01 Models
8. '96 - 98 Models: Connect the SRS main harness 18P
connector to the SRS unit, then push it into position
until it clicks.
'99 - 01 Models: Connect the SRS main harness 18P
connector and SRS floor harness 18P connector to
the SRS unit, then push it into position until it clicks.
9. Reconnect the driver's airbag 2P connector to the
cable reel 2P connector, and reinstall the access
panel on the steering wheel.
10. Reconnect the front passenger's airbag 2P ('96 - 98
Models) or 4P ('99 - 01 Models) connector to the SRS
main harness 2P ('96 - 98 Models) or 4P ('99 - 01
Models) connector, then install the glove box.
11. '99-01 Models: Reconnect the side airbag 2P con-
nectors to the SRS floor harness 2P connectors.
12. Reconnect the left side wire harness 2P connector
to the driver's seat belt tensioner and the right side
wire harness 2P connector to the front passenger's
seat belt tensioner. Reinstall the B-pillar trim panels.
13. Reconnect the battery positive cable, then the nega-
tive cable.
14. After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (II); the SRS
indicator light should come on for about 6 seconds
and then go off.
15. Enter the anti-theft code for the radio, then enter the
customer's radio station presets.