Entry Light Control System
Door Switch Test
Front Door Switch:
1. Remove the door panel (see
2.
Disconnect the 8P connector from the door lock actu-
ator assembly.
Terminal side of
male terminals
3.
Check continuity between the No. 3 and No. 8 termi-
nals.
• There should be continuity with the switch released
(door open).
• There should be no continuity with the switch
pushed (door closed).
section
20).
Rear Door Switch:
1. Remove the rear door panel (see
2.
Disconnect the 6P connector from the door lock actu-
ator assembly.
3.
Check continuity between the No. 2 and No. 6 termi-
nals.
• There should be continuity with the switch released
(door open).
• There should be no continuity with the switch
pushed (door closed).
section
20).
Terminal side of
male terminals