Acura 3.5 RL Manual page 1189

Cavity Wire Test condition
Connect battery power
to the C9 terminal, and
C8 terminal to the C1
C8 BRN/WHT
terminal momentarily.
• *
Connect battery power
C9 ORN
to the C8 terminal, and
C9 terminal to the C1
terminal momentarily.
Connect battery power
to the C2 terminal, and
C7 terminal to the C6
GRN
C2
terminal momentarily.
• •
Connect battery power
C7 BLU/GRN
to the C7 terminal, and
C2 terminal to the C6
terminal momentarily.
Connect battery power
to the C4 terminal, and
C11 terminal to the C1
YEL
C4
terminal momentarily.
• •
Connect battery power
C11 LT GRN
to the C11 terminal, and
C4 terminal to the C1
terminal momentarily.
Connect battery power
to the C3 terminal, and
C10 terminal to the C6
C3 RED
terminal momentarily.
• •
Connect battery power
C10
GRY
to the C10 terminal, and
C3 terminal to the C6
terminal momentarily.
Reconnect all connectors to the power steering control unit.
Cavity Wire Test condition
Front up-down motor
GRN/BLK
A4
runs momentarily.
• •
B1 YEL/BLK
Rear up-down motor
A4 GRN/BLK
runs momentarily.
•
B9 WHT
Slide motor runs
GRN/BLK
A4
momentarily.
•
•
B2 YEL/GRN
Recline motor runs
GRN/BLK
A4
momentarily.
•
•
10
WHT/RED
B
Test: Desired result
Check the front up-down motor
operation:
The motor should run (up)
Check the front up-down motor
operation:
The motor should run (down)
Check the rear up-down motor
operation:
The motor should run (up)
Check the rear up-down motor
operation:
The motor should run (down)
Check the slide motor operation:
The motor should run (forward)
Check the slide motor operation:
The motor should run (backward)
Check the recline motor operation:
The motor should run (forward)
Check the recline motor operation:
The motor should run (backward)
Test: Desired result
Check for voltage between the
terminals:
The voltage should pulse between
1 V or less and 4 V or more.
Check for voltage between the
terminals:
The voltage should pulse between
1 V or less and 4 V or more.
Check for voltage between the ter-
minals:
The voltage should pulse between
1 V or less and 4 V or more.
Check for voltage between the ter-
minals:
The voltage should pulse between
1 V or less and 4 V or more.
Possible cause if result is not obtained
• Faulty front up-down motor
• An open in the wire
• Faulty front up-down motor
• An open in the wire
• Faulty rear up-down motor
• An open in the wire
• Faulty rear up-down motor
• An open in the wire
• Faulty slide motor
• An open in the wire
• Faulty slide motor
• An open in the wire
• Faulty recline motor
• An open in the wire
• Faulty recline motor
• An open in the wire
Possible cause if result is not obtained
• Faulty front up-down position
sensor
• An open in the wire
• Faulty rear up-down position sensor
• An open in the wire
• Faulty slide position sensor
• An open in the wire
• Faulty recline position sensor
• An open in the wire