Acura 3.5 RL Manual page 999

Opener Cables
Removal
NOTE:
When removing the clips, use a clip remover.
Take care not to bend the opener cables.
Hood opener cable:
NOTE: Remove the inner fender (see page 20-85) and kick
panel (see page 20-43) from the left side of the vehicle.
: Clip locations
Fuel fill door opener cable:
NOTE: Remove the following parts from the left side of
the vehicle, then pull the carpet and rear carpet back, as
necessary (see page 20-46).
Front and rear side trim (see page 20-43)
Front and rear door trim (see page 20-43)
Front seat belt lower anchor (see
Center pillar trim (see page 20-43)
Rear seat cushion and rear seat-back (see page 20-67)
Trunk front trim (see page 20-44)
Spare tire lid (see page 20-44)
Rear trim panel and trunk side trim (see page 20-44)
: Clip locations
HOOD LATCH
(see page 20-88)
section 24)
HOOD OPENER
CABLE
FUEL FILL DOOR LATCH
(see page 20-89)
FUEL FILL DOOR
OPENER CABLE
Installation is the reverse of the removal procedure.
NOTE:
Make sure each opener cable is routed and con-
nected properly.
Make sure the hood and fuel fill door open properly.
HOOD RELEASE
HANDLE
(see page 20-88)
Route the opener
cable through the
holes in the body.
FUEL FILL DOOR
OPENER
(see page 20-89)