Power Steering Gearbox
Reassembly (cont'd)
72. Install the new boot bands on the boots as shown.
73. Bend both sets of locking tabs.
74. Lightly tap on the doubled-over portions to reduce
their height.
CAUTION: Stake the band locking tabs firmly.
75. Slide the rack right and left to be certain that the
boots are not deformed or twisted.
76. Install the three lines (6 mm return line, 10 mm
return line and sensor inlet line) to the valve body
unit as shown.
77. Install the line mounting cushions by aligning the
marks on the 10 mm return line (large diameter
line).
78. Loosely install the tie-rod locknuts and tie-rod ends
on the rack ends.