Acura 3.5 RL Manual page 566

26. Install the shift cable holder on the shift cable holder
base.
27. Install the shift cable cover, and install the shift
solenoid valve/A/T clutch pressure control solenoid
valve harness connector and clamp on the shift
cable cover, then tighten the bolts.
28. Connect the ATF cooler hoses to the ATF cooler
lines (see page 14-196).
29. Install the ATF dipstick tube with a new O-ring on the
torque converter housing.
30. Install the heat shields.
HEAT
6 x 1.0 mm
SHIELD
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
HEAT SHIELD
31. Install the exhaust pipe A and the three way catalytic
converter, then install the transmission stop collars.
8 x 1.25 mm
22 N-m (2.2 kgf-m
16 Ibf-ft)
Replace.
10 x 1.25 mm
54 N-m (5.5 kgf-m,
40 Ibf-ft)
Replace.
10 x 1.25 mm
38 N-m (3.9 kgf-m,
8 x 1.25 mm
22 N-m (2.2 kgf-m,
28 Ibf-ft)
16 Ibf-ft)
Replace.
32. Push the secondary HO2S connector into the vehi-
cle, then secure with the harness grommet.
33. Install the secondary HO2S harness cover.
34. Connect the secondary HO2S connector.
CARPET
HO2S (SENSOR 2) CONNECTOR
10 x 1.25 mm
33 N-m (3.4 kgf-m,
25 Ibf-ft)
Replace.
GASKET
Replace.
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)