Ipv6 Mld Query-Max-Response-Time - Cisco Sx350 Cli Manual

MLD Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Interface Configuration mode. To return to the default frequency, use the no form of
this command.
Syntax
ipv6 mld query-interval
no ipv6 mld query-interval
Parameters
•
seconds
—Frequency, in seconds, at which the switch sends MLD query
messages from the interface. The range is from 30 to 18000.
Default Configuration
The default MLD query interval is 125 seconds.
Command Mode
Interface Configuration mode
User Guidelines
Use the ipv6 mld query-interval command to configure the frequency at which the
MLD querier sends MLD host-query messages from an interface. The MLD querier
sends query-host messages to discover which multicast groups have members
on the attached networks of the router.
The query interval must be bigger than the maximum query response time.
Example
The following example shows how to increase the frequency at which the MLD
querier sends MLD host-query messages to 180 seconds:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# ipv6 mld query-interval 180
switchxxxxxx(config-if)# exit

40.5 ipv6 mld query-max-response-time

To configure the maximum response time advertised in Multicast Listener
Discovery (MLD) queries, use the ipv6 mld query-max-response-time command in
seconds
40
826