Lldp (Interface Configuration) - Cisco Catalyst 3650 series Command Reference Manual

lldp (interface configuration)

To enable Link Layer Discovery Protocol (LLDP) on an interface, use the lldp command in interface
configuration mode. To disable LLDP on an interface, use the no form of this command.
lldp {med-tlv-select tlv| receive| tlv-select power-management| transmit}
no lldp {med-tlv-select tlv| receive| tlv-select power-management| transmit}
Syntax Description
med-tlv-select
tlv
receive
tlv-select
power-management
transmit
Command Default
LLDP is enabled on supported interfaces.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
This command is supported on 802.1 media types.
If the interface is configured as a tunnel port, LLDP is automatically disabled.
Selects an LLDP Media Endpoint Discovery (MED) time-length-value
(TLV) element to send.
String that identifies the TLV element. Valid values are the following:
• inventory-management— LLDP MED Inventory Management
TLV.
• location— LLDP MED Location TLV.
• network-policy— LLDP MED Network Policy TLV.
• power-management— LLDP MED Power Management TLV.
Enables the interface to receive LLDP transmissions.
Selects the LLDP TLVs to send.
Sends the LLDP Power Management TLV.
Enables LLDP transmission on the interface.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
lldp (interface configuration)
Modification
This command was introduced.
49