Show Lldp Configuration - Cisco 300 Series Cli Manual

30
665

30.23 show lldp configuration

To display the LLDP configuration for all ports or for a specific port, use the show
lldp configuration Privileged EXEC mode command.
Syntax
show lldp configuration
Parameters
•
interface-id—(Optional) Specifies the port ID.
•
detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display for all ports. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
Example 1 - Display LLDP configuration for all ports.
switchxxxxxx# show lldp configuration
State: Enabled
Timer: 30 Seconds
Hold multiplier: 4
Reinit delay: 2 Seconds
Tx delay: 2 Seconds
Notifications interval: 5 seconds
LLDP packets handling: Filtering
Port State Optional TLVs
-------- ----- --------------
gi11 RX,TX PD, SN, SD, SC
Link Layer Discovery Protocol (LLDP) Commands
[interface-id | detailed
Address
-----------
172.16.1.1
OL-32830-01 Command Line Interface Reference Guide
]
Notifications
------------
Disabled