Defining Forward All Multicast - Cisco 200 Series Administration Manual

Configuring Multicast Forwarding

Defining Forward All Multicast

Defining Forward All Multicast
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business 200 Series Smart Switch Administration Guide
Forward All Page
The
LAGs that are to receive all of the Multicast stream from a specific VLAN. This
feature requires that the Bridge Multicast filtering in the Properties Page be
enabled. If it is disabled, then all Multicast traffic is flooded to all ports in the
switch.
You can statically configure a port to Forward All, if the devices connecting to the
port does not support IGMP and/or MLD.
IGMP or MLD messages are not forwarded to the ports are defined as Forward
All.
The configuration affects only the ports that are members of the selected VLAN.
To define Forward All Multicast:
Click Multicast > Forward All. The
Define the following:
• VLAN ID equals to—The VLAN ID the ports/LAGs are to be displayed.
• Interface Type equals to—Define whether to display ports or LAGs.
Click Go. The status of all ports/LAGs are displayed.
Select the interface that is to be defined as forward all by using the following
methods:
• Static—The port receives all Multicast streams.
• Dynamic—Not applicable.
• Forbidden—Ports cannot receive any Multicast streams, even if IGMP/MLD
snooping designated the port to join a Multicast group.
• None—The port is not currently a Forward All port.
Click Apply. The switch is updated.
enables and displays the configuration of the ports and/or
Forward All Page
14
opens.
148