Bridge Multicast Forbidden Ip-Address - Cisco Sx350 Cli Manual

4
131
switchxxxxxx(config-if)#
The following example registers the IP address and adds ports statically.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
4.6

bridge multicast forbidden ip-address

To forbid adding or removing a specific IP Multicast address to or from specific
ports, use the bridge multicast forbidden ip-address Interface (VLAN)
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
bridge multicast forbidden ip-address
interface-list |
{ethernet
no bridge multicast forbidden ip-address
Parameters
•
ip-multicast-address—Specifies the group IP Multicast address.
•
add—(Optional) Forbids adding ports to the group.
•
remove—(Optional) Forbids removing ports from the group.
•
interface-list
ethernet
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
•
port-channel-list
port-channel
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
bridge multicast ip-address 239.2.2.2
interface vlan 8
bridge multicast ip-address 239.2.2.2 add gi14
{ip-multicast-address}
port-channel-list
port-channel
ip-multicast-address
—(Optional) Specifies a list of Ethernet ports.
—(Optional) Specifies a list of port channels.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands
{add | remove}
}