Port-Channel Load-Balance - Cisco Catalyst 3650 Command Reference Manual

port-channel load-balance

port-channel load-balance

To set the load-distribution method among the ports in the EtherChannel, use the port-channel load-balance
command in global configuration mode. To reset the load-balancing mechanism to the default setting, use the
no form of this command.
port-channel load-balance {dst-ip| dst-mac| dst-mixed-ip-port| dst-port| extended| src-dst-ip| src-dst-mac|
src-dst-mixed-ip-port| src-dst-port| src-ip| src-mac| src-mixed-ip-port| src-port}
no port-channel load-balance
Syntax Description
dst-ip
dst-mac
dst-mixed-ip-port
dst-port
extended
src-dst-ip
src-dst-mac
src-dst-mixed-ip-port
src-dst-port
src-ip
src-mac
src-mixed-ip-port
src-port
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
50
Specifies load distribution based on the destination host IP address.
Specifies load distribution based on the destination host MAC address. Packets
to the same destination are sent on the same port, but packets to different
destinations are sent on different ports in the channel.
Specifies load distribution based on the destination IPv4 or IPv6 address and the
TCP/UDP (Layer 4) port number.
Specifies load distribution based on the destination TCP/UDP (Layer 4) port
number for both IPv4 and IPv6.
Sets extended load balance methods among the ports in the EtherChannel. See
the port-channel load-balance extended command.
Specifies load distribution based on the source and destination host IP address.
Specifies load distribution based on the source and destination host MAC address.
Specifies load distribution based on the source and destination host IP address
and TCP/UDP (layer 4) port number.
Specifies load distribution based on the source and destination TCP/UDP (Layer
4) port number.
Specifies load distribution based on the source host IP address.
Specifies load distribution based on the source MAC address. Packets from
different hosts use different ports in the channel, but packets from the same host
use the same port.
Specifies load distribution based on the source host IP address and TCP/UDP
(Layer 4) port number.
Specifies load distribution based on the TCP/UDP (Layer 4) port number.
Layer 2/3 Commands
OL-32639-01